|
||||||||
|
|
||||||||
|
|
SEELER ENTERPRISES DAMAGE CONTROL UNIT (SP-A001) **THIS UNIT IS SPECIAL ORDER ONLY**  The SP-A001 Shoulder Pack (ECU) was designed specifically for shipboard damage control and rescue. It requires no tools to recharge its 20 minute oxygen supplly and is rechargeable while in use. Easily handed through a porthole, it can be put to use in a completely flooded compartment, to de-water or remove interference. Add a single hose divers regulator with a quick connect plug, turn the oxygen supply regulator to 80 PSI or 90 PSI and a damage controlman can inspect a flooded compartment. The multiple uses of the Emergency Cutting Unit are limited only by your imagination. The Shoulder Pack is the only product of its type in the country. The Exothermic Cutting Equipment can cut materials extremely fast, is very quiet to operate, is small, lightweight and very portable. It could be utilized to disable a vehicle, cut through ducts for alternate access, etc. These units will cut high tensile steel in a time unparalleled by any conventional equipment. Steel barred doors or windows can be opened in a matter of seconds. The Seeler Enterprises Exothermic Emergency Cutting Unit can be used by personnel with little or no training and is virtually maintenance free. Normally, the only after-purchase replacement items would be the self-consuming cable, which burns at a rate of two feet per minute, and the oxygen consumed. Federal Regulations stipulate that compressed gas bottles must be hydro tested every 5 years. TECHNICAL DATA: Nomenclature: S.E.I. Shoulder Pack Emergency Cutting Unit Approximate Weight: Shipping Weight 65 lbs. Operational Weight 44 lbs. Stock No.: SP-A001 (NSN#9C42200135908-49) Cost: P.O.R. Cutting Time: 20 minutes with fully charged bottle/longer with practice. Cable Burn Rate: Maximum 2 ft. per minute. Oxygen Capacity: 80 cubic feet. Components: 1. Storagae box. 2. Control head and valve assembly. 3. One 5 ft. stainless steel H.P. charging whip. 4. One 5 ft. stainless steel L.P. whip with thumb activated deadman switch. 5. 80 cubic foot oxygen bottle. (NOT FOR MEDICAL USE) 6. Cable cutters. 7. Unit carrying strap. 8. Protective eye wear. 9. Protective gloves. 10. One 25 ft. roll 6mm Exothermic Cable. (NSN#9C4220013590850) Additional supplies include: tape, knife, steel wool, 9 volt battery, head wrench, two Hansen Fittings, double male oxygen connector (CGA.540) for oxygen plant charging. Gauge face plates are removable for flushing and cleaning. KEEP VALVES CLEAN. |
|
||||||
SEELER ENTERPRISES, INC.
